1.2.7p() w.r.t 1.2.7d 
-------------------------------
(*) Updated user interface to not display AES when not licensed.
(*) Updated to add 18GHz T/R 1008 to the diplexer selection.
(*) Updated to add new TR 252 entry to 6GHz diplexer table. 
(*) Updated to also store/restore 10G switch configuration.
(*) Updated to add capability to upload license using CLI/SNMP (using TFTP).
(*) Updated to increase traffic mux clock speed to its maximum to support AES data rate up to 2.3Gbps through one Traffic Mux.
Note, when AES is disabled, each Traffic Mux supports data rate up to  2.5Gbps.
(*) Updated to remove 1+0 (4*CA) use cases from the user interface.
(*) Improved DPD auto calibration.
(*) Improved graph pages in the web.
(*) Resolved miscellaneous bugs in CLI.
(*) Resolved miscellaneous bugs in AES.
(*) Resolved an issue with use case 1+0 (2*Carrier Aggregation) not locking.


1.2.7q() w.r.t 1.2.7p 
-------------------------------

(*) Resolved an issue with SNMP "snmpwalk" command


1.2.74() w.r.t 1.2.7q 
-------------------------------


(*) Improved SNMP MIBs based on customer feedback.
(*) Improved SNMP backward compatibility with 1.2.4m software.
(*) Allowing user to configure frequencies outside the diplexer min/max garudband range with a warning message.  
(*) Fixed an issue related to LAG system ID during configuration restore.


Note: Clear your browser cache after uploading the package.